Concrete slab cost in Crestview, FL

Climate in Crestview: timing your concrete slab job

We use NOAA's 1991-2020 climate normals for Crestview Bob Sikes Ap (5 miles from the city center). These are 30-year monthly averages, not forecasts.

February through May and September through December are the stretches where pouring concrete runs into the fewest weather problems in Crestview (8 of 12 months). January has an average overnight low of 40°F or below; June, July and August have an average daytime high of 90°F or more.

The 40°F line is a deliberately cautious stand-in. The American Concrete Institute's cold-weather guide (ACI 306R-16) defines cold-weather concreting around an average daily air temperature below 40°F, which is colder than our test of an average overnight low at or below 40°F, so we flag a few extra shoulder months. In cold weather crews may need heated enclosures, insulating blankets or accelerated mixes, and those measures can raise a quote.

Heat matters for concrete as well. With average highs of 90°F or more in June, July and August, crews often start early, wet the base and plan for faster set times.

Crestview gets about 64 inches of precipitation in a normal year. The wettest months are June, July and August (7.9 inches in July). Inside the workable window, May and October are the driest, at 4.1 and 4.1 inches. The station averages about 98 days a year at 90°F or above.

Does the season change the price? Probably, but we do not have a sourced seasonal price curve, so the estimator shows a year-round figure and does not adjust by month. When you collect quotes, ask whether scheduling in a slower month gets a better rate.

Specs and site conditions that change a Crestview bid

• Base and reinforcement

  A compacted gravel base, vapor barrier, and wire mesh or rebar are priced separately by some contractors and bundled by others. Ask which one your quote does.

• Truck and pump access

  If the mixer truck can't back up to the forms, someone has to wheelbarrow it in or hire a pump. Pump or line-pump hire is typically billed per day.

• Small-job minimums

  Many crews have a minimum charge, so a 10x10 pad can cost more per square foot than a 20x20 slab.

Extras that change the Crestview total

Extras are quoted nationally and then scaled to Crestview by the average of the local wage index (0.88) and goods index (0.96), a factor of 0.92. Tick any of them in the estimator above to add them to your total. Treat these as planning figures: an add-on touches different trades than the main job, so the scaling is an approximation.

Planning more than one job in Crestview?

Because every project leans on different trades, Crestview's wage level does not move all prices equally. Against the US midpoint, asphalt driveway runs −7% and concrete driveway −9%.

Crestview: what basic, standard and premium work costs

Three bands are cut from the same cited range and localized for Crestview wages and prices. They overlap on purpose: a good standard job and a modest premium job can cost the same. The grid below prices the same bands at 5 common sizes.

Crestview against nearby metros and the rest of Florida

Contractors rarely work more than an hour or two from home, so the neighboring metros set a rough ceiling and floor for your quotes. Midpoints for 400 sq ft range from $3,300 to $3,550 across Crestview and its five closest metros.

Across 300 US metros, Crestview comes in at #196 from the top. The priciest is Kahului, HI at $5,300; the cheapest is McAllen, TX at $3,200 (midpoints, 400 sq ft). Statewide, Crestview is 1% below the Florida figure.

Other Florida metros

Cities with a workforce like Crestview's

Big cities and small ones price differently, so here is Crestview against the 4 metros with the closest total employment.

Crestview labor market for concrete slab

Wages are the part of this estimate that changes most from town to town. 4 trades carry the job here, and each is compared with its US median. The weighted result for Crestview is 0.88 times the national level.

For cement masons and concrete finishers (47-2051, weighted 50%) the local median is $23.62 an hour, which is 14% below the national $27.41. The middle half of them earn between $21.54 and $28.48 an hour. BLS counts 200 of them working in the area, 16.0 for every 10,000 jobs (US: 13.3), so the local bench is deeper than average.

Construction laborers (47-2061), 30% of the weighting: a median of $21.72 an hour, 4% below the US median of $22.66. The middle half of them earn between $18.08 and $23.06 an hour. About 1,000 work in the metro. That is 80.0 per 10,000 jobs, compared with 70.5 nationally, so the supply of crews looks typical.

For operating engineers and other construction equipment operators (47-2073, weighted 10%) the local median is $23.39 an hour, which is 19% below the national $28.78. The middle half of them earn between $22.35 and $29.37 an hour. BLS counts 390 of them working in the area, 31.2 for every 10,000 jobs (US: 30.7), so the local bench is about average.

For carpenters (47-2031, weighted 10%) the local median is $23.53 an hour, which is 19% below the national $29.12. The middle half of them earn between $20.91 and $28.14 an hour. BLS counts 370 of them working in the area, 29.6 for every 10,000 jobs (US: 43.1), so the local bench is thinner than average.

Quotes come from real crews, not medians. If the cement masons and concrete finishers on your job are paid at the 75th percentile ($28.48 an hour) instead of the median, the labor line grows by about $140. At the 25th percentile ($21.54) it shrinks by about $60. The total moves by 4.0% or 1.7%, so wages alone rarely explain a quote that is far outside our range.

For context on the local economy, BLS counts 125,050 jobs in the Crestview-Fort Walton Beach-Destin area. That makes it the 172nd largest of the 300 metros we cover, with 0.08% of US employment.